Drill-doctor XP Manuel d'utilisateur télécharger pdf (Page 6)

www.drilldoctor.com 98 www.drilldoctor.com

Aligning the Drill Bit

This makes sure that the Drill Doctor creates the right

geometry. And, it sets the bit so that only a small amount

of the tip is taken off.

(See page 17 to align and sharpen a Masonry drill bit.)

Insert bit in Chuck

and tighten

Insert the bit into the Chuck

Jaws and close the Jaws just to

the point where the bit slides in

and out. Do not over tighten the

Chuck; the bit needs to be able

to move in and out until Step 4.

Note: A good test to see if the

Chuck is tightened the correct

amount is to make sure it

moves when you pull on it with

your fingers, but will not fall

out when you turn the Chuck

upside down.

Insert Chuck into

Alignment Port

Press the Align-

ment Button

down and hold

it. Match the

either of the

Alignment

Guides on the

Chuck with the 118°

Notch on the Alignment

Port. Insert the Chuck.

While holding the button

down, slide the drill bit for-

ward until it touches the Drill

Stop and the Chuck is pullsed

all the way into the Align-

ment Port. Release the

Alignment Button.

Adjust Bit Position

Look at your bit and make

sure the Bit Clamp Arms are

in the bit’s narrowest spot. If

they aren’t, turn the bit in the

chuck so that it is held by the

Bit Clamp Arms at its narrow-

est width. This is important

because this setting deter-

mines the angle at which your

bit will be sharpened.

Tighten Chuck

Hold onto the Chuck and

tighten the Chuck Knob.

(Avoid over-tightening the

Chuck in the Alignment Port.

This could damage the Chuck

and Port.)

Remove and re-tighten

Press the Alignment Button

and remove the chuck from

the Alignment Port. Tighten

the Chuck once more to

ensure the bit won’t move

when you sharpen it.

You are now ready to sharpen

the drill bit.

Alignment Button

Drill Stop

Alignment

Port

Alignment

Guide

Bit Clamp Arms

Drill Stop

118˚

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Drill-doctor XP Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Drill-doctor XP